Accessories; Wa-Isc 240 Angle Stop; Environment - Festool ISC 240 Li Manual De Instrucciones Original

English

10 Accessories

The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet at "www.festool.com".

10.1 WA-ISC 240 angle stop

The WA-ISC 240 angle stop [14-1] is used to
saw flexible insulating materials with the FS/2
guide rail.
Fitting the angle stop on the guide rail [14]
The angle stop can only be fitted to the
side of the guide rail where the guide
spring [14-2] can engage in the guide
groove [14-3].
► Release the rotary knobs.
► Place the angle stop on the guide rail
and push it forwards until it is fully fitted on
the guide rail.
► Tighten the rotary knobs.
The angle stop is firmly seated in the guide.
Adjust the stop ruler [14-4].
►
Setting the angle [15]
► Release the rotary knob.
► Set the desired angle by using the point­
er.
► Tighten the rotary knob.
Move the angle stop into the transport posi­
tion. [16]
► Release the rotary knobs.
► Pull the angle stop out of the guide rail
by 5 cm.
► Turn the angle stop clockwise by 90°.
► Push the angle stop on the guide rail into
the transport position.
► Tighten the rotary knobs.
To move the angle stop back into the working
position, carry out the steps in reverse order.

11 Environment

Do not dispose of the tool in the house­
hold waste!Recycle tools, accessories
and packaging. Observe applicable na­
tional regulations.
EU only: In accordance with European Directive
2002/96/EC on waste electrical and electronic
equipment and implementation in national law,
used power tools must be collected separately
20
and handed in for environmentally friendly re­
cycling.
Information on REACh: www.festool.com/reach