Care Instructions - ION DOCUSCAN Manual Del Usuario

CARE INSTRUCTIONS

To get high image quality and good recognition results, please follow these steps to clean the scanner.
Notes:
• Make sure the cleaning and calibration paper, and cleaning stick are clean and without any dust before use.
• Do not use any solvent to clean the sensor.
1. Insert the cleaning paper into the scanner's FEED SLOT as if you were going to scan it.
2. Press the SCAN button to scan the paper.
3. Put your thumbs in the FEED SLOT and pull the cover upwards to remove it from the scanner.
4. Insert the thin end of the cleaning strip into the slot of the scanner at the rear side. Move the strip from one side to the
other slightly a few times then remove it.
Note: Do not insert the cleaning strip into the FEED SLOT at the front side of the scanner. This may damage the
internal components.
5. Replace the FEED SLOT cover by aligning the edge's two latching tabs with the mounting holes on the scanner and
pushing the cover in until it clicks back into place.
CALIBRATION
1. Insert the calibration paper (with the white side facing down) into the FEED SLOT.
2. Press the MENU button to bring up the System Menu.
3. Use the LEFT / RIGHT buttons to select "Setup" (the "wrench" icon) then use the UP / DOWN buttons to select
"Calibration."
4. Press the OK button to begin the calibration process.
Note: The process will take few minutes to complete, and it will shut down automatically. Turn the power on again if you
want to use the scanner.
6