Dexter 800AG2-125.5 Manual De Instrucciones página 200

d) The rated speed of the accessory must be at least equal to the
maximum speed marked on the power tool.
than their rated speed can break and y apart.
e) The outside diameter and the thickness of your accessory must be
within the capacity rating of your power tool.
accessories cannot be adequately guarded or controlled.
f) Threaded mounting of accessories must match the grinder spindle
thread. For accessories mounted by flanges, the arbour hole of the
accessory must fit the locating diameter of the flange.
that do not match the mounting hardware of the power tool will run
out of balance, vibrate excessively and may cause loss of control.
g) Do not use a damaged accessory. Before each use inspect the
accessory such as abrasive wheels for chips and cracks, backing pad for
cracks, tear or excess wear, wire brush for loose or cracked wires. If
power tool or accessory is dropped, inspect for damage or install an
undamaged accessory. After inspecting and installing an accessory,
position yourself and bystanders away from the plane of the rotating
accessory and run the power tool at maximum no-load speed for one
minute.
Damaged accessories will normally break apart during this test
time.
h) Wear personal protective equipment. Depending on application, use
face shield, safety goggles or safety glasses. As appropriate, wear dust
mask, hearing protectors, gloves and workshop apron capable of
stopping small abrasive or workpiece fragments.
must be capable of stopping ying debris generated by various operations.
The dust mask or respirator must be capable of ltrating particles
generated by your operation. Prolonged exposure to high intensity noise
may cause hearing loss.
i) Keep bystanders a safe distance away from work area. Anyone
entering the work area must wear personal protective equipment.
Fragments of workpiece or of a broken accessory may y away and cause
injury beyond immediate area of operation.
j) Hold power tool by insulated gripping surfaces only, when
performing an operation where the cutting accessory may contact
hidden wiring or its own cord.
Accessories running faster
Incorrectly sized
Cutting accessory contacting a "live" wire
200
Accessories
The eye protection
FR
ES
PT
IT
EL
PL
RU
UA
RO
EN