Dexter 800AG2-125.5 Manual De Instrucciones página 210

Maintenance
Always be sure that the tool is switched o and unplugged before attempting to
perform inspection or maintenance.
If the supply cord of this power tool is damaged, it must be replaced by a
specially prepared cord available through the service organization.
Cleaning
The tool and its air vents have to be kept clean. Regularly clean the tool's air
vents or whenever the vents start to become obstructed.
Avoid using solvents when cleaning plastic parts. Most plastic parts are
susceptible to damage from various types of commercial solvents and may be
damaged by their use. Use clean clothes to remove dirt, carbon dust, etc.
Lubrication
All the bearings in this tool are lubricated with a su cient amount of high
grade lubricant for the life of the unit under normal operating conditions,
therefore no further lubrication if required.
Storage
Store the angle grinder in a dry place. Regularly inspect the disks / wheels,
ensure that the disks / wheels is free of cracks and surface defects. Replace the
disks / wheels when it has wore out.
Take care not to expose this tool to the rain.
10. CHECK THE DELIVERY PARTS
Carefully remove the tool from its packaging and check if the following parts
are complete:
1 x Angle grinder
1 x Side handle
1 x 115mm grinding protective cover
1 x 125mm grinding protective cover(assembled on the machine)
1 x spanner
1 x External ange (assembled on the machine)
1 x Internal ange(assembled on the machine)
210
FR
ES
PT
IT
EL
PL
RU
UA
RO
EN