Charging The Unit - Profi Care PC-HSM Manual De Instrucciones

Table: Cutting step versus cutting length
Cutting step Cutting length
1= approx. 3.0 mm
3= approx. 6.0 mm
5= approx. 10.0 mm
7= approx. 13.0 mm
9= approx. 16.0 mm

Charging the Unit

• Turn the unit off. "0" can be seen on the switch (6).
• Connect the power adaptor connector with one of the following jacks.
• The socket directly at the bottom end of the unit (5).
• Alternatively place the unit in the charging station. The socket is at the rear.
• Plug the power adaptor into a 230 V/50 Hz wall outlet.
• The indicator light remains red during the charging process.
NOTE:
The charge indicator does not indicate the state of charge of the rechargeable battery.
• Charge the unit before first use for 10 hours.
NOTE:
• After initial use, do not charge the battery for longer than 8 hours at one time.
• If the battery is empty, the appliance can be operated from the mains. To do so, con-
nect the adapter directly to the clipper.
CAUTION:
After 8 hours always disconnect from mains power supply.
English
71