Important-Safety Precautions - Zodiac Tower 2176 T/R – T Manual Del Usuario

1. Important-Safety Precautions

This device of which operation is subject to the following two conditions：
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
 T o prevent fire or shock hazard, do not expose this device to rain or
moisture.
Do not use near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet
basement, or near a swimming pool.
 T o avoid electrical shock, do not open this device.
 T his device should be operated to use only the power supply included with
it or provided as an accessory.
 D o not overload wall outlets and extension cords as this can result in the
risk of fire or electrical shock.
 D o not attempt to service this device yourself. Refer servicing to qualified
personnel only.
Note:
This equipment has been tested and found to comply with the limits
for a class B digital device, pursuant to Part 15 of the FCC Rules, or BZT
and CE EMC directive. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, if not
installed and used in accordance with the instruction, it may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
 R eorient or relocate the receiving antenna.
 I ncrease the separation between the equipment and receiver.
 C onnect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
 C onsult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by
the Party responsible for compliance could void the user's
authority to operate the equipment
14