Publicidad
Idiomas disponibles
Idiomas disponibles
COD.
Cv
A
56550
1 II
622
56551
1 II
720
56552
2 II
720
INSTALLATION
This appliance must be installed by a trained pool professional service technician. When installing the
appliance, ensure all parts are installed in the correct zone in accordance with the wiring rules. In particular
refer to AS/NZS 3000 (Australia) and EN 60364 (EU).
A. Plan position of pump so that it will be:
1. Free of water flooding, such as in a sump, garden hollow, ditch or at bottom of bank with run off.
2. On a stable base so that:
a)
The pump is not left suspended by its fittings, causing a leak or failure with loss of water.
b)
Movement through vibration is restricted
c)
No strain is put on attaching pipe or other expensive equipment
3. Accessible for maintenance and easily removed for service.
4. Breathing space. Pump should not be crowded which will prevent cooling airflow from fan.
Overheating due to lack of cooling voids warranty.
5. Within reach of power point without extension/plugs liable to corrosion, shorting, etc.
6. At a minimum height of suction lift of water from pool surface to pump inlet.
B. For best pump performance keep suction pipe length as short as possible with minimum number of bends
and use 50mm high pressure PVC suction and return pipe. All equipment such as filters, heaters,
chlorinators must have a minimum of 50mm connections.
C. Secure the barrel unions supplied into the attaching pipe work, using approved priming fluid and solvent
cement as normal practice, coating both surfaces. NOTE: Always wear protective gloves when handling
Installation and General Maintenance Manual – Viron eVo Pool Pump
B
C
E
480
300
346
480
300
346
480
300
346
F
G
H
215
345
300
215
345
300
215
345
300
I
D
120
50
120
50
120
50
7
Publicidad
