Operating Manual; Introduction; How Does The Whirl System Function; How Does The Air System Function - HOESCH Reviva Instrucciones De Montaje Y Manejo

14

Operating manual

Finally: you are about to bathe for the first time in your HOESCH whirl tub! We wish you a lot of pleasure in your
new bathtub! The fact that you have a highest quality product is the effect of constant monitoring of the product,
research and development works in connection with the innovative design of our luxurious bathtubs made of
sanitary acrylic. However, in order for your bathing not to be disturbed, we suggest reading this manual first.
15

Introduction

15.01

How does the whirl system function?

The whirl system has a closed water circulation. The drain valve is at the same time the sucking connector. Water is sucked
in/ out, the whirl pump accelerates its flow so that the water under the pressure of approx. 1 bar is forced in by massage
jets to the inside of the bathtub. Thanks to the generated negative pressure an automatic air enrichment takes place (this
function can be switched on and off with the use of the remote control). Pipes between the jets and the pump are located in
such a way that they get empty during draining the bathtub.
In the Whirlpower system the air enrichment takes place with the help of the blower, which provides even stronger and more
powerful massage. Thanks to the rotating jets such massage stream evenly reaches all parts of your body.
15.02

How does the Air system function?

The air sucked by the blower is carried by air pipes located under the bottom of the bathtub and via bottom nozzles to the
inside of the bathtub full of water.
16

Remote control 433 MHz, in compliance with CE

2 1
3
5
4
6
8
7
9
10
11
Depending on the type of the water massage system the following functions
are assigned to individual buttons:
Whirlpower + Air
1 Whirl ON/OFF / Whirl +
2 Whirl -
3 Whirl ON/OFF at intervals
4 Air ON/OFF / Air +
5 Air -
6 Air ON/OFF at intervals
7 Plus Air ON/OFF
8 Whirlpower EIN/AUS
9 Underwater LED spotlights
10 Semi-automatic disinfection
11 Switch off everything
send - LED
Whirlsystem
1 Whirl ON/OFF / Whirl +
2 Whirl -
3 Whirl ON/OFF at intervals
9 Underwater LED spotlights
10 Semi-automatic disinfection
11 Switch off everything
send - LED
Display module
yellow
red
green
Whirlpower
1 Whirl ON/OFF / Whirl +
2 Whirl -
3 Whirl ON/OFF at intervals
8 Whirlpower ON/OFF
9 Underwater LED spotlights
10 Semi-automatic disinfection
11 Switch off everything
send - LED
Airsystem
4 Air ON/OFF / Air +
5 Air -
6 Air ON/OFF at intervals
7 Plus Air ON/OFF
9 Underwater LED spotlights
10 Semi-automatic disinfection
11 Switch off everything
send - LED
Green LED diode
■ Whirl tub ready to work/standby, i.e. the minimum water
level has been reached
Yellow LED diode
■ it is on when you the disinfection is required
Red LED diode
■ it is on during disinfection process
■ It pulses after finishing the disinfection and signals that
the bathtub should be emptied
GB
27