Parrot SEQUOIA Manual De Usuario página 19

Make sure that the Sequoia cables do not get caught in the
!
drone propellers during the flight.
Connecting Sequoia to a USB battery
You can use Sequoia without a drone. To do this, you need a 2,4A USB
battery at least.
1. Connect the multispectral sensor to the sunshine sensor using the
USB host cable.
2. Connect the multispectral sensor to the battery using the USB
device cable.
> Sequoia turns on automatically (Diagram C).
Calibrating Sequoia
Before using Sequoia, you must calibrate it. Before starting the
calibration, make sure that the two sensors are properly attached and
connected to the drone.
The multispectral sensor and the sunshine sensor must be
!
attached perpendicularly. It is recommended to calibrate the
two sensors at the same time.
Note: You can calibrate the sensors separately. However the
sunshine sensor must be connected to the multispectral sensor
to be calibrated.
Diagram C
Diagram B
19