Parrot SEQUOIA Manual De Usuario página 40

this user guide conforms with technical standards EN300328 (v1.8.1),
EN301489-17 (v2.1.1), EN 60950-1:2006/A11:2009/A1: 2010/A12:
2011/A2: 2013 in accordance with the provisions of the R&TTE Directive
1999/5/EC, the Low Voltage Directive 2006/95/EC and the RoHS
Directive 2011/65/EC.
Declaration of Conformity in Canada
This Class B digital camera complies with Canadian standards ICES-003
and RSS-210.
This device complies with the Industry Canada RSS applicable to
license-exempt radio apparatus. Operation is permitted subject to the
following two conditions:
(1) the device must not produce interference, and (2) the user of the
device must accept any radio interference encountered, even if the
interference is likely to compromise operations.
FCC/IC
To comply with the FCC/IC RF exposure guidelines for transmission
equipment, a distance of at least 20cm must be maintained between
the product antenna and individuals. To remain compliant it is not
recommended to use the product at any distance less than this.
Federal Communications Commission (FCC) Statement.
To meet the FCC/IC requirements on exposure to RF for transmission
devices, a distance of at least 20 cm must be maintained between the
product's antenna and people. To ensure compliance, it is recommended
that the device not be used at any shorter distance.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates or
uses or can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
40