Alessi MG32 Manual De Instrucciones página 16

Equipment description
A Kettle in stainless steel
B Bird anti-spray cap
C Lid
D Lid knob
E Protective ring
F Anti-scale filter
G Power base
H ON/OFF switch
D
B
F
A
Fig. 1
Before using the equipment
• Remove all the packaging from
the kettle and from the power
base.
• Remove the anti-scale filter using
a long (but not pointed) object,
pushing down through spout
towards the inside of the kettle
until the filter comes out of its
housing (fig.2).
Fig. 2
• Wash the filter thoroughly.
• Fill the kettle and bring it to the
boil (see the next paragraph: using
the kettle). Repeat this operation
twice to make sure the kettle is
clean.
• Install the filter: keeping the tab
at the top pointing towards the
inside of the kettle, first position
the bottom edge and then push
E
C
H
G
towards the spout until the filter
clicks into place (fig.3).
Power base
• The power base allows the kettle
to be placed and used on it at any
angle.
• To extend the cable, turn the
power base upside down and
unroll the electrical cable from
the cable holder. Pull out
the right amount
of cable needed
to reach the
power socket,
using the slots
provided (fig.4).
• Do not allow the
cable to hang from the
worktop.
• Remove the kettle from the power
base before filling it.
• Remove the lid and fill the kettle
up to the required level (fig. 5).
• Do not fill the kettle from the
spout.
• Fill the kettle with only as much
water as you intend to use: this
will reduce
boiling time.
Remember
that less boiling
time means
less limescale
building up.
• Fill the kettle
with at least a
cup of water
(minimum level) so that it will not
boil dry; incorrect use such as this
will greatly reduce its working life.
13
Fig. 3
Using the kettle
Filling
Fig. 4
Fig. 5