Carat P-3500 Manual De Instrucciones página 29

• The P-3500 is made to operate under the
conditions indicated
OPERATION ALLOWED", in the "TECHNICAL
DATA" paragraph;
• During cutting operations, allow the machine to
rest as indicated;
• P-3500 is not made to operate continually under
a load.
WARNING !
DANGEROUS SHARDS
THEMSELVES DURING CUTTING. TO REDUCE
THE RISKS ARISING FROM FRAGMENTATION OF
MATERIALS, USE APPROPRIATE PROTECTIVE
GOGGLES.
WARNING !
CONTINUOUS USE OF THIS MACHINE FOR 8
(EIGHT) HOURS RESULTS IN EXPOSURE TO
NOISE EXCEEDING 85 DB(A). IT IS THEREFORE
NECESSARY TO WEAR EAR MUFFS THAT
FULFIL LEGAL REQUIREMENTS.
3. Installation
Position the machine on a stable surface.
To set the machine for operating, proceed as
follows:
WARNING !
MAKE SURE THAT:
• THE MOTOR HEAD IS LOCKED USING THE
LOCKING KNOB ON THE SLIDING BEAM.
• THE MACHINE IS IN A 30° POSITION AND
THE KNOBS
INCLINATION ARE PROPERLY TIGHTENED.
a) move the leg clamps to the released position
(photo 1);
1 1
under "TYPE
MAY DETACH
FOR ADJUSTING
b) use the transporting handles to lift one side of
OF the equipment to the working position (photo 2);
WARNING !
IN ORDER TO FACILITATE THE INSTALLATION
OPERATIONS,
TROLLEY ON THE OPPOSITE SIDE TO THE ONE
THAT MUST BE LIFTED.
WARNING !
TO POSITION THE MACHINE CORRECTLY
MAKE SURE THAT THE UPPER HOLE IN THE
LEGS IS ALIGNED WITH THAT IN THE LEG
CONNECTION BEFORE FINALLY CLAMPING IT
(PHOTO 2).
c) lock the legs in position, one at a time (photo 2);
2 2
WARNING !
SUPPORT THE MACHINE WHILE LOCKING THE
LEGS IN POSITION.
THE
d) Repeat this operation on the opposite side;
e) Loosen the trolley-locking knob on the sliding
beam (photo 3);
3 3
29
POSITION THE CUTTING
GB