Important Information - ergoCentric upCentric 2L Manual Del Usuario

Important information

• Always make sure all screws are tightened before
use of the table and after moving or transporting.
• Duty cycle of the frame for desk is 10 %, max.
2 minutes operating/min. 18 minutes stop.
• Maximum load of the table is 250 lbs (114 kg). Ensure the loading
on each leg is less than 125 lbs (57 kg) otherwise it might cause
permanent damage to the leg(s) during operation.
• When the motor cable is connected to the control box the legs
can maintain an adequate locking force up to 250 lbs (114 kg)
load on the tabletop. However, when the cable is damaged or
is disconnected from the control box, it will cause the desk to
sink to the bottom within hours if the load on either leg is
larger than 125 lbs (57 kg).
• Make sure that no persons or items will collide with
the table, when adjusting upwards and downwards.
• Damaged cords must be replaced before connecting
the main power cable.
• Keep at least ¾" of free space around the whole frame/tabletop.
• The upCentric is not intended to be used as a person lift.
• Do not pull or push the table if adjusting.
• Do not lift the frame above the table off of ground when adjusting.
3