Descargar Imprimir esta página

BH Tecnovita YV16 Instrucciones De Montaje página 12

Plataforma vibratoria

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 1
• Serious types of hernia.
• Hip and knee prostheses (at high
vibration levels).
• Epilepsy.
• Use
of
osteosynthetic structures in general or
any other internally fitted electric device.
• Tumours and metastatic processes.
• Being particularly tired, unwell or
overly stressed.
• Inflammation caused by injuries of
an electro-muscular nature.
• Do not use after surgery (for at least
2 months), post-traumatic situations or
transient generic illnesses such as
headache, backache, etc. ... until the
symptoms disappear.
• Vocal cord disorders.
• Use of contraceptive coils (IUD)
• Psychological
vibratory stimulation.
SAFETY INSTRUCTIONS.-
This product is supplied with a mains
cable that has an earth wire and a plug
with an earth pin. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock.
Do not modify the plug supplied with
the equipment, if it does not fit the wall
socket then get an electrician to install
an electrical socket that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig.A.
plates,
pins
intolerance
and
Always
recommendations:
1
Never
recommended by the manufacturer.
2
Do not use the machine if the mains
cable becomes damaged or worn.
3
Keep the mains cable away from hot
surfaces.
4
Do not use the machine outdoors.
5
To unplug the machine, first put the
switch to the "0" position and then
to
unplug it from the wall socket.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect both
the electronic and electrical circuits.
This safety device (fuse) will be
automatically triggered if the unit is
subjected to abnormal force or heat.
1.- Set switch (L), located on the
casing, to the "0" (OFF) position.
2.- Change the fuse (C) (7 Amp).
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again. (Fig B)
12
observe
the
use
accessories
Fig B
following
not

Publicidad

loading