Hayward Swimclear Manual Del Usuario página 15

⚠
WARNING
– This product should be installed and serviced only by a qualified pool professional.
FILTER DISASSEMBLY INSTRUCTIONS
1. Turn off all system circulation pumps and all electric power on the pad.
2. Set all system valves in a position to prevent water flow to the filter.
3. The manual air relief valve must be placed in the OPEN position. (FIG 2)
4. Remove filter drain plug (FIG 4) and drain water from filter.
5. Using ¾ inch wrenches, loosen and remove the clamp nut and the clamp bolt.
6. Holding both ends of the filter body clamp carefully spread the clamp ends. Remove the clamp by lifting over the upper
filter body. Do not to drop the clamp during removal because the clamp could be damaged. Do not strike the clamp with
metal tools as they can damage the clamp.
7. Lift off upper filter body. Do not use the pressure gauge to lift the upper filter body.
DEX2422Z2 Metal
reinforced seal
Top Manifold
Lower Body
seal Surface
Figure 4
Drain plug
with O-Ring
CLEAN SEAL RING AND SEAL SURFACE
1. Remove filter tank seal.
2. With a clean cloth wipe the lower filter body seal surface. (Fig 4) Do not use a solvent.
3. With a clean cloth wipe the upper filter body seal surface.
⚠
Notice: Do not use any petroleum solvents to clean filter components.
Do not lubricate DEX2422Z2 Seal.
Page 6 of 8
MAINTENANCE
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
REMOVING CARTRIDGES
1. Remove the top Manifold, which is exposed when the upper filter body
is removed. (Fig 4)
2. Remove the filter cartridge elements by using slight rocking motion and
lifting up.
3. Clean filter cartridge elements.
CLEANING CARTRIDGES
The Cartridge filter element can be cleaned by washing inside and outside
with a garden hose. After hosing cartridge, for best results, carefully brush
the pleated surface to remove fine particles. Do not pressure wash as it
can damage the filter element.
You may find some debris on the cartridge pleats, which may not have
been removed with hosing.
CLEANING CARTRIDGES
1. Flush and drain any dirt or debris from the bottom of the lower filter body.
2. Flush any dirt or debris from the upper filter body and from around the
manual air relief area.
3. Carefully replace the cartridges over the hubs on the bottom seal plate.
4. Place top manifold securely on top of cartridges, aligning the return pipe
with the port in the manifold
SwimClear™ Rev. B