Publicidad
Idiomas disponibles
Idiomas disponibles
SLIPPER CLUTCH GUIDE
Your Redcat Gen8 features an adjustable slipper clutch. Out of the box the slipper clutch is set at the factory to
work best for most situations. Follow the steps below to fine tune the slipper clutch.
A
DJUSTING
R
ECOMMENDED
The recommended slipper clutch setting is 75% throttle. You can check this by holding the car still on carpet,
with a fully charged battery, and gradually applying throttle. You should hear the slipper clutch begin to slip at
approximately 75% throttle. If the slipper clutch begins to slip before 75% throttle, tighten the M4 nut
approximately ¼ turn and try again. If the slipper clutch begins to slip after 75% throttle, or does not slip at all,
loosen the M4 nut approximately ¼ turn and try again. Please note that over the life of your vehicle, it is
normal for the slipper pads will wear out and will need to be replaced periodically. It is recommended to check
your slipper clutch performance every 4-5 hours of use.
S
LIPPER
You can eliminate the slipper from the vehicle by removing the slipper pads and spring washers. The images
below show correct assembly of the slipper shaft with a working slipper and eliminated slipper.
Note: Eliminating the slipper increases the potential of drivetrain damage.
WORKING SLIPPER
Redcat Racing
T
S
HE
LIPPER
Remove the rubber dust cover and adjust the slipper by inserting
a 7mm hex driver to turn the slipper nut.
Note: You must hold the drivetrain still during this process.
Note: The slipper is very sensitive to adjustments. In most
cases, half a turn is all that is needed.
S
LIPPER
C
E
LUTCH
LIMINATION
Slipper Pads
Spring washer orientation.
C
LUTCH
Remove the rubber
cover
C
S
LUTCH
ETTINGS
Metal Hexes
16
Use a 7MM hex driver
to adjust slipper nut
ELIMINATED SLIPPER
Publicidad
