Troubleshooting - Ampro A3659 Manual Del Usuario

Maintenance
WARNING: Always disconnect from the air supply and depressurise before
cleaning or carrying out any maintenance.
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts
to wear quickly, and shorten the machine's service life. Clean the body of
your machine with a soft brush, or dry cloth
IMPORTANT: There is very little that can go wrong with your air tool and it
should be noted that when an air tool fails to work it is generally because
the internal workings have corroded due to dirty, wet air and failure to
follow the instructions given below.
Daily maintenance procedure: Disconnect from the air supply, pour the
equivalent of a tablespoon of oil into the air intake. Connect tool to the air
supply and run motor briefly (e.g. 2-4 seconds) at low speed to distribute
the oil.
Once a week: Disconnect tool from the air supply. Remove the
connector and pour in a few drops of air tool oil. Replace connector .
Connect tool to the air supply and run motor briefly (e.g. 2-4 seconds) at
low speed to distribute the oil.
• If the machine is in constant use or used for long periods at a time, a
combined filter/lubricator must be fitted. There must be an air filter fitted
at all times
• Use air tool oil. DO NOT UNDER ANY CIRCUMSTANCES USE NORMAL
ENGINE OIL
• Failure to comply with the operating and maintenance instructions may
invalidate the guarantee

Troubleshooting

Problem
Tool operating slowly
Tool seized
Normal no load speed but tool
slows down under load
Tool will not stop after trigger is
fully released
If the above troubleshooting solutions fail, contact your dealer or an authorised AMPRO service centre.
Industrial Air Tools
Possible Cause
Pressure incorrect
Dirt within the mechanism
Air blockage
Air leak
Blockage in gauze mesh filter
Dirt or rust in mechanism
Dirt or rust in mechanism
Dirt or rust in mechanism
Worn motor or clutch parts
Motor or clutch sticking
Throttle valve O-ring or valve seat damaged
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
• As with other power tools, air tools should not be disposed of with
household waste
• Air tools may contain traces of tool oil and other lubricants and so must
be recycled accordingly
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
Solution
Set the correct air pressure according to the specification
Pour oil into air inlet as per maintenance instructions
Operate tool in short bursts to clear blockage
Check all fittings and hose for air leaks and correct issue by re-
tightening, using PTFE tape or replacing
Remove quick connector and clean mesh filter
Try 'Tool operating slowly' solutions
Tap tool gently with a soft mallet
Free mechanism by rotating drive manually when disconnected from
air line
Contact an authorised AMPRO service centre
Pour oil into air inlet as per maintenance instructions and operate tool in
short bursts to lubricate and free up
Have the tool repaired at an authorised AMPRO service centre
A3659