The Frame; Push Bar; Brake P; The Bassinet - Mutsy Transporter Manual De Instrucciones

English
assembly and dismantling of the front
wheels
· In order to install the front wheels the
vertical wheel axle is inserted in the
swivel housing on the frame. Push the
wheel into the wheel tube. When the
wheel has been inserted as far as pos-
sible into the wheel tube, press on the
round cover cap above the wheel tube.
The wheel is now locked in place. (B1)
· The front wheels are removed by
pressing in the round button above
the wheel and pulling the wheel axle
out of the tube. (B2)
Front wheels to swivel mode
· Move the pedal levers on both wheel
forks upwards. (C1) The front wheels
will now swivel.
· Locking the swivel system: Move
the pedal levers on both wheel forks
downwards. (C2) The wheels will now
lock when they are returned to their
original straight-ahead position.

The frame

Folding out the frame
· Apply the brake or place a foot on the
rear axle.
· Move the upper frame upwards (D1)
until a click is heard. (D2)
· Press in the buttons on the sides of
the handle grip. (D3)
· Twist the handle grip upwards and re-
lease the button when the push bar is
in the desired position. (D4)
! Before each use, check that the strol-
ler is correctly unfolded and locked.
Folding the frame
· Apply the brake or place a foot on the
rear axle.
· Press in the buttons on the sides of
the handle grip and twist the grip to
place it in its lowest position. (E1)
12
· This position is indicated by the circle
marked on the hinge point. (E2)
· Pull the unlocking slides on the inner
side of the frame towards you (E3)
and press down on the frame. (E4)

Push bar

· The push bar can be adjusted be-
tween four pushing positions and a
folded position.
· Press in the buttons on the sides of
the handle grip to make these adjust-
ments.
· With the buttons pressed in, the han-
dle grip can now be moved to the de-
sired position. (F)
Brake
· Gently move the brake rod (in front of
the rear axle) downwards with the foot
to apply the brake.
· Move the brake rod (in front of the rear
axle) upwards to release the brake. (G)

The bassinet

· The bassinet is used to carry a baby
(from birth up to 15 kg / 33 lbs) in a
horizontal position.
· The bassinet can also be removed
from the stroller so that the baby can
be placed elsewhere while remaining
in the cot.
Fitting the bassinet
· Remove the cover caps from the cen-
tral attachment points by pressing on
the lip (below the attachment point
and then sliding the cap upwards at
an angle. (H)
! Keep the cover caps safe, you will
need them again later.
· Slide the adapters over the attachment
points until they click into place. (I)
! Attach the adapter marked R on
theright and the adapter marked L on