Fellowes POWERSHRED Serie Manual De Uso página 3

ADVANCED PRODUCT FEATURES
SAFESENSE ® TECHNOLOGY
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
2 3 4
1
Turn the shredder Touch test area and SafeSense is active and If hand is held on
®
ON ( ) to activate look for the SafeSense working properly SafeSense
®
SafeSense indicator to illuminate than 3 seconds shredder
®
will shut off
For more information about all of Fellowes Advanced Product Features go to www.fellowes.com
PRODUCT MAINTENANCE
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run
even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry.)
TO CLEAN THE SENSORS
2
1 3
Turn off and unplug Lift CD flap Locate Auto-start
shredder infrared sensor
AUTO OIL TM
Automatically oils the cutters to enhance performance and extend shredder life.
(Auto oil system is only included on cross-cut models - 425Ci and 485Ci)
REFILLING THE OIL
1 2
3
Low oil indicator will To maintain shredder Once refilled, automatic
signal when your reservoir performance, refill oil oiling will resume
needs refilling reservoir with up to 12
oz. (355 ml.) of shredder
oil (Fellowes 35250)
• All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and
could ultimately stop running. We recommend that you refill the Auto Oil
• If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain,
remove plug and let oil drain out. Replace plug.
4
425_485i_Ci_406025RevI_090314_18L.indd 4-5
Models 425Ci/425i/485Ci/485i
ENERGY SAVINGS SYSTEM
Optimal energy efficiency 100% of
the time – in use and out of use.
• Saves energy in four ways: energy-efficient electronics, jam prevention,
standby mode and sleep mode.
• Sleep Mode shuts down shredder after 2 minutes of inactivity.
WHEN IN SLEEP MODE
2 3
1
area more
®
In sleep mode To get out of sleep mode or
touch control panel
4 5
Dip cotton swab in Using cotton swab, wipe
away any contamination
rubbing alcohol
from the paper sensors
TM reservoir as instructed for optimum performance.
ENGLISH
PREVENTIVE MAINTENANCE & ACCESSORIES
TROUBLESHOOTING
Low Oil Indictor: When illuminated, the shredder is out of oil and needs to be refilled. See the Product Maintenance section for refill instructions.
For optimum performance, use Fellowes oil (35250). *Auto Oil™ is only featured on cross cut models – 425Ci and 485Ci.
Bin Full Indicator: When illuminated, the shredder waste bin is full and needs to be emptied. Use Fellowes waste bag 3605801.
SafeSense ® Indicator: If hands are too close to the paper entry, the SafeSense
is active for 3 seconds, the shredder will automatically turn off and the user must press the power button on the control panel to resume shredding.
Remove Paper Indicator: When illuminated, press reverse (
Door Open Indicator: The shredder will not run if the cabinet door is open. When illuminated, close the door to resume shredding.
Straight Feed Indicator: When illuminated, remove paper and feed straight into paper entry.
JAM PROOF SYSTEM*
insert paper
Eliminates paper jams and powers through tough jobs.
DISABLING THE FEATURE
1
2
AUTO
AUTO
Should you choose to Once disabled, the
disable the system, press blue Auto light is
and hold the auto and no longer illuminated
reverse ( ) buttons at (To re-engage,
the same time repeat step 1)
*100% Jam Proof when used in accordance with user manual
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date
of purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be
free from defects in material and workmanship for 20 years from the date of purchase by the
original consumer. If any part is found to be defective during the warranty period, your sole and
exclusive remedy will be repair or replacement, at Fellowes' option and expense, of the defective
part. This warranty does not apply in cases of abuse, mishandling, failure to comply with product
usage standards, shredder operation using an improper power supply (other than listed on the
label), or unauthorized repair. Fellowes reserves the right to charge the consumers for any
® indicator will illuminate and the shredder will stop shredding. If SafeSense
) and remove paper. Reduce paper quantity to an acceptable amount and refeed into paper entry.
4 4 5
3
Shredding can continue If jam occurs, press and If not cleared, press
with the system disabled; hold forward ( ) reverse ( ) briefly
however, a paper jam button until the document (repeat steps 4 and 5
may occur with too many is completely through the until shredded)
sheets and Remove Paper
shredder
icon ( ) will illuminate
additional costs incurred by Fellowes to provide parts or services outside of the country where the
shredder is initially sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION
TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable
for any consequential or incidental damages attributable to this product. This warranty gives you
specific legal rights. The duration, terms, and conditions of this warranty are valid worldwide,
except where different limitations, restrictions, or conditions may be required by local law. For
more details or to obtain service under this warranty, please contact us or your dealer.
®
6
If steps 4 and 5 do
not clear jam, reverse
paper all the way out,
remove several sheets
and refeed
5
9/3/14 2:53 PM