Provider checklist
Before leaving a DeVilbiss iFill Personal Oxygen Station with a user, the following checklist MUST be completed:
1.
Check all parts for shipping damage. In case of damage, do not use. Contact DeVilbiss for further instructions.
2.
Make sure the hydrostatic test on the oxygen cylinder has not expired.
3.
Instruct the user on the safe operation of the personal oxygen station and review ALL warnings.
4.
Leave a copy of this instruction guide with the user.
NOTE– DeVilbiss recommends leaving a full cylinder of oxygen with the patient AFTER setting up the personal oxygen station, and instructing the patient to always keep a
filled cylinder on hand.
INTRODucTION
This instruction guide will acquaint you with the DeVilbiss iFill Personal Oxygen Station. Make sure that you read and understand this guide before operating your oxygen
station. Important safeguards are indicated throughout this guide; pay special attention to all safety information. Contact your DeVilbiss equipment provider should you have
any questions. NOTE– All references to cylinder throughout the guide represent an oxygen cylinder.
INDIcATIONS FOR uSE
The Model 535I Oxygen Cylinder Filling System is intended for use in supplying pressurized oxygen to fill oxygen cylinders for patients' ambulatory use. The device is intended
to provide 93% (±3%) oxygen. This device can be used in homes, nursing homes, patient care facilities, etc.
IMPORTANT PARTS
DeVilbiss iFill Personal Oxygen Station (Figures A & b)
1.
Oxygen Fill Connector (referred to as Fill Connector throughout guide)
2.
Oxygen Fill Connector Cover/Cylinder Adapter (referred to as Fill
Connector Cover and/or Cylinder Adapter throughout guide)
3.
Oxygen Fill Port Collar (referred to as Fill Port Collar throughout guide)
4.
Instruction Label (Figure C)
5.
Indicator Panel Label (Figure C)
6.
Start/Stop Switch
7.
Cradle
8.
Fused Mains Inlet
9.
Front Handle
10. Rear Handle
11. Carry Handle Recess
12. Air Filter(s) (2 - one on each side)
13. Hour Meter - behind filter on Indicator Panel label side (right side)
iFill Instruction and Indicator Panel Labels (Figure c)
Instruction Label
1.
Set cylinder regulator to "Off"
2.
Remove cap from iFill unit
3. Dock oxygen cylinder into oxygen fill connector, click in place
4.
Push Start/Stop button
5.
Depress port collar, lift cylinder. Replace cap
Indicator Panel Label
6.
Service Required (Red) LED
7.
Standby (Green) light
8.
Full (Green) light
9.
Filling (Green) LED
iFill Oxygen cylinder & Regulator (Figure D)
1.
Rotary Selector
2.
Nipple Connector
3.
Hydrostatic Test Date - Contact your homecare provider or the cylinder
manufacturer for details.
4.
Cannula Fitting
5.
Shut Off Valve
Accessory/Replacement Parts
Air Filter(s) . . . . . . . . . . . . . . .535D-605 (6 filters)
Mains Fuse. . . . . . . . . . . . . . .535I-610
iFill Oxygen Cylinder . . . . . . . . . . Refer to Cylinder Chart
EN - 4
1
7
10
8
11
Figure A
1
2
3
4
5
5
PD1000A series iFill
Cylinder w/Integrated
PulseDose Regulator
7
3
9
4
12
13
Figure B
6
7
8
9
Figure C
1
4 (on
rear)
2
2
5
3
Figure D
535CF series iFill
Cylinder w/Continuous
Flow Regulator
2
5
6
SE-535I