HQ-Power VDPDMXBAR3 Manual De Uso página 5

• F + SIGNAL SELECT + RESET BUTTONS
Press this combination to reset the whole system, which enables you to return to the initial settings.
• The MASTER indicator blinks when the preheating function is available.
• The SIGNAL indicator goes out.
• FULL ON & STAND BY
FULL ON & STAND BY are only available in MASTER mode. Press FULL ON to activate the full on function of
the whole channel output, the DISPLAY will show FUL. Press STAND BY to turn off the whole channel, STD
will appear.
• The DISPLAY shows OUT and the channel indicators will stop blinking after 10 seconds when operation is
paused.
INDICATION
L - -
R - -
NOR
CRO
OUT
IN
FUL
STD
D00 – d99
F00 – f99
A01 – A99
P01 – P16
E00 – E25
001 - 512
c. DMX-512 Connections
Connect the provided XLR cable to the female 3-pin XLR output of
your controller and the other side to the male 3-pin XLR input of the
VDPDMXBAR3. Multiple VDPDMXBAR3s can be linked through
serial linking. The linking cable should be two core, screened cable
with XLR input and output connectors.
Please refer to the diagram at the right.
VDPDMXBAR3
EXPLANATION
Data information of CH1 – 4 corresponding to outputs CH1 – 4
Data information of CH1 – 4 corresponding to outputs CH4 - 1
Output 0 – 100 % dimming enabled
Only full on and stand by enabled, dimming disabled
0 – 100 % dimming level
Fade time with a range of 0 – 10 seconds
Speed with a range of 1/60 – 20 steps/second
PROGRAM 1 – 16
Preset minimum dimming level of 0 – 25 %
5
DMX output
DMX input
FULL ON
STAND BY
DMX address
VELLEMAN