Tabla de contenido
Publicidad
R&S SFD
1.3 Preparing for Operation
The following section describes how to prepare the instrument for operation and how
to connect external devices. Please observe the general safety instructions for
operating the instrument.
1.3.1 Shipping
The R&S DOCSIS Signal Generator (SFD) is comprised of very sensitive electronic
components that are susceptible to damage during shipment if not properly packaged.
It is recommended to always use original product shipment packaging when shipping
the SFD anywhere. In instances when the original shipping container is no longer
available the SFD must be packaged in a double walled cardboard box or stronger
package with at least 4 inches of expanding foam or new bubble wrap on all sides,
edges, corners and faces of the SFD. The package must have "Handle with Care" and
"Do Not Drop" labels affixed to the exterior of the box in a clearly visible manner. If not
properly packaged the warranty and standard repair fee are void.
1.3.2 Unpacking the Instrument
●
After unpacking the instrument, check the supplied equipment against the delivery
note to make sure all items are present.
●
Carefully check the instrument for possible damage.
●
Should there be any damage, please inform the carrier immediately. Keep the
packing material to support your claim.
●
The original packaging is also useful for transporting or shipping the R&S SFD
later on.
1.3.3 Standalone Operation & Orientation
The instrument is designed for interior use only as a standalone device.
Please note that permitted operating orientation for the R&S SFD is horizontal (NOT
tilted by 90° such that the left or right side is pointing upwards). The area next to the
unit must remain un-obstructed to provide adequate airflow through the meshed
ventilation grid on each side.
Getting Started 2118.7546.02 - 02
Putting the Instrument into Operation
Preparing for Operation
7
Publicidad
Tabla de contenido
