Power Supply - Roadstar CLR-2495P Manual De Instrucciones

POWER SUPPLY

This unit operates from a main supply of 230V ~ 50Hz. Connect the AC
power cord to the AC household main outlet. Ensure that the voltage
is as indicated on the rating plate on the rear of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time
and alarm settings in the event of a temporary power interruption.
Install a 9-volt battery (type 6F 22/006P), not included, into the battery
compartment located on the bottom of the unit.
Note: We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid
possible battery leakage.
If power is temporarily interrupted the display will blink and the radio
will not play. However, the battery back-up circuit will continue to
maintain the clock and alarm settings. When power is restored the clock
will display the correct time and alarm settings, and no adjustment is
necessary.
Note: If power is interrupted and there is no battery in the compartment
or the battery is exhausted. The time and alarm settings will be
lost. When power is restored the clock will begin to flash
indicating that the time and alarm settings must be corrected.
3 4
English
CLOCK
1. Set the ON/OFF/AUTO switch (1) to 'OFF' connect the Main Cord
2. To set the correct time, press the TIME SET button (6) and MINUTE
3. Open the Clock Battery Compartment door and fit a 9V battery. The
NOTE: THE LED DIGITAL CLOCK AND THE PROJECTION
CLOCK MUST BE SET SEPARATELY
TIME SETTING FOR PROJECTION
-
-
-
English
to the power supply. The clock display will flash on and off
indicating a power interruption and that the display time is
incorrect.
SET button (10), or HOUR SET button (9), together, until the correct
time is displayed.
purpose of this battery is to store the information relating to alarm
time. And to keep the clock functioning in the event of disconnection
from the mains supply or power interrruption. Should this occur. The
clock will continue to keep time, but will not display.
Switch the projection switch to the 'ON' position.
To preset the HOURS, press simultaneously the HOUR BUTTON
(21) and the TIME BUTTON (20), keep them depressed until the
hour digits to be preset are displayed.
To preset the MINUTES, press simultaneously the MINUTE
BUTTON (22) and the TIME BUTTON (20). Keep them depressed