Power Supply; Settingthecorrecttime - Roadstar CLR-2510 Manual De Instrucciones

All manuals and user guides at all-guides.com
POWERSUPPLY
This unit operates from a main supply of 230V ~ 50Hz. Connect the AC
power cord to the AC household main outlet. Ensure that the voltage
is as indicated on the rating plate on the rear of the unit.
Battery Back-up Power Failure Protection
This radio has a battery back up circuit that will keep the correct time
and alarm settings in the event of a temporary power interruption.
Install a 9-volt battery (type 6F 22/006P), not included, into the battery
compartment located on the bottom of the unit.
Note: We recommend an alkaline battery for longer usable life.
Change the battery every 9 to 12 months for best result and avoid
possible battery leakage.
If power is temporarily interrupted the display will blink and the radio
will not play. However, the battery back-up circuit will continue to
maintain the clock and alarm settings. When power is restored the clock
will display the correct time and alarm settings, and no adjustment is
necessary.
Note: If power is interrupted and there is no battery in the compartment
or the battery is exhausted. The time and alarm settings will be
lost. When power is restored the clock will begin to flash
indicating that the time and alarm settings must be corrected.
English 3 4

SETTINGTHECORRECTTIME

1. Press and hold the TIME SET Button (11).
2. Press HOUR button (2) to advance hour
3. Press MINUTE button (3) until the correct time is displayed.
4. Release the TIME SET Button (11).
SETTINGTHE WAKEUPTIME
1. Set the FUNCTION Selector (1) to the OFF position.
2. Set the alarm time by following this procedure:
3. Press and hold the ALARM SET Button (4).
4. Press the HOUR Button (2) to advance hour; press MINUTE Button
(3) until the desired alarm time is displayed.
5. Release the ALARM SET Button (4).
6. To check the correct alarm time is set, press the ALARM SET Button (4).
WAKETOBUZZERALARM
1. Set the alarm time as shown above.
2. Set the Function Selector (1) to the AUTO position.
"" will appear on the left side of the display.
3. Turn the VOLUME Control (10) down completely.
4. To switch off the alarm either press the ALARM OFF Button (5), or
set the FUNCTION Selector (1) to the OFF position.
English