Raid Setup Procedure (Pcie Ssds) - bto X-BOOK 15CL78 Manual Del Usuario

RAID Setup Procedure
(PCIe SSDs)
1. Go to the operable computer and insert
a USB flash drive.
2. Insert the Device Drivers & Utilities +
User's Manual disc into the CD/DVD
drive of the operable computer.
3. Copy the f6flpy-x64 folder from the
location below (D: denotes your DVD
drive) on the Device Drivers & Utilities
+ User's Manual disc to the USB flash
drive.
• D:\Options\RAID\f6flpy-x64
4. Start-up your notebook computer and
press F2 to enter the BIOS.
5. Go to the Boot menu, select UEFI
Setting and press Enter.
6. Set UEFI Boot to "Enabled".
7. Press Esc to exit the menu and go to the
Advanced menu.
8. Select SATA Mode, press Enter and
select "RAID Mode".
9. Press F4 and <Yes> to "Save Changes
and Reset".
10. After the computer restarts press F2 to
enter the BIOS again.
11. Go to Intel(R) Rapid Storage
Technology (in the Advanced menu)
and press Enter.
12. Select Create RAID Volume and press
Enter.
8
13. You can now setup your RAID volume
using any two installed disks.
14. Go to Name: and press Enter (see
Figure 2 on page 7).
15. Type a name of your choice for your
RAID volume and press Enter.
16. Go to RAID Level: and press Enter.
17. Choose the RAID Level required (see
Table 2 on page 6) and press Enter.
• RAID 0 (Stripe)
• RAID 1 (Mirror)
18. Go to any of the disks listed under
Select Disks: and select a disk name
and press Enter.
19. Move the cursor down (use the arrow
keys) onto X (or select the disk required)
and press Enter (see
Figure 3 on page
7) .
20. You should select two identical disks to
form your RAID volume.
21. If you have selected RAID 0 (Stripe)
then you can adjust the "Strip Size" to
your requirements (It is recommended
that you set the "Strip Size" to 128KB).
22. Go to Create Volume and press Enter.
23. The RAID volume will then be created
and the RAID information will be
displayed under Intel(R) Rapid Storage
Technology (in the Advanced menu).
24. Press Esc to exit the menu.
25. Press F4 and <Yes> to "Save Changes
and Reset".
26. Make sure your USB flash drive is
attached to one of the USB ports on the
computer.
27. Make sure the Windows 10 OS DVD is
in the attached DVD drive and as the
computer starts up it will automatically
boot from the Windows 10 OS DVD
(you will be prompted to press a key to
boot from the DVD).
28. Click Next > Install Now to continue
installing the operating system as
normal (see your Windows
documentation if you need help on
installing the Windows OS).
29. A prompt will appear to ask you to Load
Driver.
30. Click Browse and browse to the location
you copied the files to on your USB flash
drive (X: denotes your USB flash drive):
• X:\f6flpy-x64
31. Click Next.
32. Follow the on-screen instructions to
install the Windows 10 operating system.
33. Install the Windows drivers as per
Table 7 on page 31. Make sure you
install the Intel® Rapid Storage
Technology (IRST) driver (see
page 32).