Warranty; Operating-Presentation-Interfaces; Operating Principle; Overview Presentation - Cristec YPO-DISPLAY-R Manual Del Usuario

1.2

WARRANTY

CRISTEC waives all liability if the installation rules and instructions for use are not observed.
The warranty is valid for 24 months. It covers parts and labour for equipment returned to the Quimper plant (France).
Only original parts recognized as being defective will be replaced under the warranty.
Our warranty does not cover :
1. Failure to abide by this manual
2. Any mechanical, electrical or electronic alterations to the appliance
3. Improper use
4. Presence of moisture
5. Failure to comply with DC power‐supply tolerances (i.e. overvoltage)
6. Incorrect connections
7. Falls or impacts during transportation, installation or use
8. Repairs carried out by anyone unauthorized by CRISTEC
9. The maintenance made by a non‐authorized person by CRISTEC
10. Connection of any interface not supplied by CRISTEC
11. The cost of packaging and carriage
12. Apparent or latent damage sustained during shipment and/or handling (any such claims should be sent to the
haulier)
Our warranty on no account provides for any form of compensation. CRISTEC shall not be held liable for damage
incurred as a result of using the Remote Display.
2 OPERATING‐PRESENTATION‐INTERFACES
2.1 O
PERATING PRINCIPLE
The Remote Display and its interface board are designed to offer all available information about the charging process
while the charger is running as well as to supervise batteries when AC network is off.
The Remote Display and the interface board are powered by the battery connected to +BAT E.
In case batteries remain uncharged during min. 4 weeks (wintering), please disconnect the batteries
connected to +BAT E terminal in order to avoid discharging due to continuous consumption.
2.2 O
VERVIEW PRESENTATION
The product consists of two parts:

The interface board which handles the communication between the
YPOWER battery charger and the Remote Display. It also handles the
voltage measurement for the Remote Display when the battery
charger is off‐grid.

The full colour touch screen Remote Display which is connected via a 3
pole cable to the interface board. The Display is supplied by the
battery connected to the charger's output terminal +BAT E through
the connection cable.
Removed front
cover
18