Display Setup; Charger Setup - Cristec YPO-DISPLAY-R Manual Del Usuario

5.1 D
ISPLAY SETUP
5
4
5
4
5.2 C
HARGER SETUP
4
3
3
3
2
1 : Brightness Day
2 : Display Auto Off
3 : Home (return to main page)
4 : Language
1
5 : Reset to Factory Data
Auto Off is dedicated to reduce the
load on the battery connected to
2
+BAT E terminal while the charger is
off‐grid. The Remote Display will
enter into sleep mode after the
selected time interval. It will return
into operation mode again by
pressing the screen.
1 : LIN Interface software version
2 : LIN Interface hardware version
3 : Home (return to main page)
4 : Remote display hardware version
1
5 : Remote display software version
2
1 : Output 1 label selection
2 : Home (return to main page)
3 : Output 2 label selection
4 : Output E label selection
Label is set according to installation:
‐ Not Active
1
‐ Starter
‐ Start PORT
‐ Start STB
‐ House
‐ House 1
‐ House 2
‐ Bow thruster
‐ Gen Set Start
‐ Navigation
‐ Auxiliary
‐ Other
26