Dometic Waeco SinePower MSP 1012 Instrucciones De Uso página 51

_MSP702_MSP2524.book Seite 51 Dienstag, 22. September 2009 4:55 16
SinePower
11.1 Set energy saving mode (Standby)
In energy saving mode, the inverter does not release any voltage, thereby
preserving the battery. If a connected appliance requires power which is
more than the pre-set power value, the inverter reverts to normal operation.
You can switch to energy-saving mode using the DIP switches S1, S2 and
S3 (fig. 3 1, page 4) and set the power value.
The switch positions for your inverter can be found in the following table:
Energy-saving mode up to
MSP 702
MSP 704
Off
15 W
25 W
40 W
50 W
65 W
75 W
85 W
11.2 Switch between 50 Hz and 60 Hz.
The output voltage can be switched between 50 Hz and 60 Hz with the DIP
switch S4 (fig. 3 1, page 4).
Warning!
e
Only adjust the S4 DIP switch when the respective frequency for
the output voltage should be used.
Set the S4 DIP switch (fig. 3 1, page 4) according to the following table:
Output voltage frequency
MSP 1012 MSP 2012
MSP 1024 MSP 2024
MSP 1512 MSP 2512
MSP 1524 MSP 2524
Off
20 W
40 W
55 W
75 W
95 W
115 W
135 W
50 Hz
60 Hz
DIP switch
S1
Off Off
40 W On
80 W Off
125 W On
170 W Off
210 W On
245 W Off
280 W On
S4 DIP switch
Off
On
Using the inverter
S2 S3
Off Off
Off Off
On Off
On Off
Off On
Off On
On On
On On
51