Miscellaneous; Cleaning And Maintenance - Medisana LSC Instrucciones De Manejo

GB
3 Operating / 4 Miscellaneous
3.2
Changing the
fluorescent lamps

4 Miscellaneous

4.1
Cleaning and
maintenance
14
On average, the fluorescent lamps need to be changed after approximately
8000 hours' use. If a lamp fails, it must be replaced.
In order to change a fluorescent lamp, the appliance must be completely
disassembled. Have the lamps changed by your specialist dealer, an authorised
service centre or a qualified specialist to prevent damage to the appliance.
WARNING
• Used fluorescent lamps must be disposed of in accordance with
the applicable regulations on environmentally harmful waste.
If you have any questions about disposal, contact your local
authority or your dealer.
• Before changing the fluorescent lamps, the device must always
be switched off using the ON/OFF switch
plug must be disconnected from the mains socket.
Beware of electric shock.
• Be careful when handling fluorescent lamps – they can easily
break.
• Always replace fluorescent lamps with lamps of the same type.
Always replace both lamps at the same time.
• Before cleaning the appliance, switch it off using the ON/OFF button
pull the power plug
• Let the appliance cool down completely before cleaning it.
• Do not immerse the device in water or other fluids.
• When cleaning the device, never use aggressive cleaning agents, scouring
agents or solvents; neither should you use scouring pads, steel wool or tough
brushes. This can damage the surfaces.
• Clean the appliance using a soft, lint-free cloth, if necessary dampened with
mild, warm soapy water and well wrung out. Do not allow water to penetrate
the appliance.
• Only use the appliance again after cleaning once it is completely dry.
• Do not expose the unit to direct sunlightor high temperature; protect it
against dust and moisture.
• Keep the appliance in a safe, dry place, preferably in the original packaging.
out of the socket. Risk of electric shock!
and the power
and