installation guide
Always use two people when setting up the base, moving or flipping the base.
STEP 1
Place the bed base box in a desired location with the bottom of
the box facing up .
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects .
STEP 2
Remove the bed base from the box keeping the bottom of
the base facing upwards .
If installing a Divided King, please refer to Divided King
Installation Guide
STEP 3
To install headboard brackets (sold separately)
see instructions on page 14 and 15
To install the legs, thread the washer over the screw on the leg .
Next, screw the leg into the nutsert on the frame . Do not over
tighten.
The 3-in-1 legs untwist into separate sections for custom leg
height options .
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
8
STEP 4
To sync two bases with the SmartSync™ cord - see page 13
Uncoil the Power Down Box from the frame
and place the box on the ground . Ensure
that it is easily accessible when the base is
turned to its upright position .
STEP 5
Uncoil input cord (connected to control box's
power port) and plug into Power Supply .
STEP 6
Uncoil the Power Cord and connect to the
Power Supply . Place Power Supply on the
ground and extend from the base . Ensure
that the Power Supply and all attached
cords are directed toward the desired
surge protector .