Syncing Two Bases - Serta Motion Essentials Manual Del Usuario

syncing two bases (optional)
A Sync Cord is included with the base. Not available on Queen, Full, Full-Long, or Divided King size bases.
The Sync Cord connects the two control boxes to a single remote for the synchronization of two bases.
STEP 1
Unplug bases from power source .
STEP 2
Disconnect the Power Down Box cable from each Control
Box or splitter cable . Make note where the cable was
plugged in .
STEP 3
Connect the male end of each Sync Cord to Control
Box or splitter cable . Insert it into the same port that you
disconnected the Power Down Box from in Step 2 .
STEP 4
Connect each Power Down Box male connection to the
sync cord female connection (refer to illustration at right) .
STEP 5
Plug bases back into the power source .
STEP 6
Check to ensure all cords are securely attached . Both remotes
will now operate both bases simultaneously .
The system is now linked . Buttons pressed on either remote
will control both bases simultaneously .
Control Box 1
Power Down
Box 1
PERFORMANCE NOTES
If bases become mismatched, pressing the FLAT button will re-
sync the mechanical positions .
Sync Cord
Control Box 2
Power Down
Box 2
13