Troubleshooting - OK. OTD 202-D Manual De Instrucciones

CLEANING AND CARE
• Re-insert the condenser. Fix the locking levers. Close the condenser door until it
locks into position.
Note: Do not use sharp tools for cleaning the condenser.

TROUBLESHOOTING

The following circumstances do not constitute problems. Do not contact the service
centre until the problem has been confi rmed.
Problem
Tumble dryer
fails to operate.
Tumble dryer
fails to oper ate.
Indicator End
lights up.
Drying time is
too long and
the results are
not satisfactory.
OTD 202_A5_130723 (1.5).indb 49 OTD 202_A5_130723 (1.5).indb 49
Cause
• Poor connection to the power
supply.
• Power failure.
• No drying program is set.
• Device has not been switched
on.
• The water collection tank is
full.
• The tumble dryer door is not
properly closed.
• The laundry has reached the
condition defi ned by the
program setting.
• There is no laundry in the
drum.
• The program setting is not
correct.
• The fi lters have not been
cleaned.
• The condenser is blocked.
• The tumble dryer is
overloaded.
49
Solution
• Check connection to the power
supply.
• Check the power supply.
• Set a drying program
• Switch on the device.
• Empty the water collection
tank.
• Close the tumble dryer door
properly.
• Make sure the program is set
correctly.
• Check if there is laundry in the
drum.
• Check if your program setting
is appropriate.
• Clean the fi lters.
• Clean the condenser.
• Reduce the amount of laundry
in the drum.
EN
22/7/13 4:13 PM 22/7/13 4:13 PM