Troubleshooting - OK. OTD 28111 Manual De Instrucciones

ERROR INDICATION AND TROUBLESHOOTING
Error indication shown in display and remedy
Follow below table to understand error messages and to remedy. Error messages are shown in display
during use.
Error
message
Water tank full or pump
is flashing
error
Air circulation blocked
is flashing
E30 Error of heating system
E32 Error of humidity sensor
E33 Error of temperature sensor
Front temperature sensor
(E33)
E34
Rear temperature sensor
(E34)

TROUBLESHOOTING

Problem
Display doesn't work
Dryer doesn't start
Water leakage
Door opens by itself or cannot
be closed
Humidity in the room
increasing significantly
Degree of dryness not
reached or drying time too
long
IM_OTD28111_150320_V04_HR.indb 34
34
Reason Alarm signal
If the error code
is shown an
alarm signal
occurs every 15
minutes.
Solution
• Power supply
• Check preset program
• Check fuses of you electric supply
• Make sure the door is closed
• Chose correct program and push button Start/Pause
• Align dryer horizontally.
• Check air condenser, sealing cap and drainage and make sure it is
installed correctly.
• If the problem persists contact your service agent.
• Close door slowly until it clicks. Do not slam the door.
• Remove clothes if overloaded
• Ventilate room adequately.
• Clean the air inlet grille.
• Ensure that the air condenser has been inserted.
• Clean lint filter and wash condenser.
• Empty condensation water tank.
• Clean the moisture sensors.
• Use next higher drying program or use Timer program.
Remedy
– • Empty condensation water tank.
• Check drainage and make sure it
is not blocked
• If the error code is sill shown
there, contact your service agent.
– • Clean the lint filter.
• Open the service flap of air inlet
and make sure grill and filter are
not blocked.
• Contact your service agent
20/3/15 6:29 PM