Oehlbach SCOPE VISION OUTDOOR Manual Del Usuario página 10

INSTALLATION
Internal/external wall mounting (Fig. 1)
Step 1. Mark the mounting position with a pen or pencil (use the mounting bar for this purpose).
Step 2. Use the supplied screws to screw the mounting bar to the wall.
You may need to use wall plugs depending on the wall. Use a 6 mm drill bit to drill a hole
approx. 35 mm deep.
Step 3. Secure the antenna to the mounting bar.
Step 4. Connect the antenna cable to the antenna and then run the cable to your set-top box or TV.
Step 5. Proceed as described in the section entitled "INITIAL OPERATION".
Mounting the mast (Fig. 2)
Step 1. Secure the mounting bar to a suitable mast by using the threaded brackets and wing nuts.
Step 2. Secure the antenna to the mounting bar.
Step 3. Connect the antenna cable to the antenna and then run the cable to your set-top box or TV.
Step 4. Proceed as described in the section entitled "INITIAL OPERATION".
10
BDA_Scope_Vision_Outdoor.indd 10 23.11.17 13:40