Control Panel Navigation - HQ-Power VDPLP64SL Manual Del Usuario

number of fixtures on a serial data link is 32 fixtures.
• A DMX terminator is recommended for installations where the DMX cable has to run a long distance
or is in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the
digital control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120Ω
resistor between pins 2 and 3, which is then plugged into the XLR output socket of the last device
in the chain.
c) general
• Make sure there is no flammable material within a 50cm radius of the device and there is sufficient
cooling.
• Have a qualified electrician carry out the electrical connection.
• Connect the device to the mains with the power plug. All fixtures must be powered directly off a
grounded switched circuit and cannot be run off a rheostat or dimmer circuit, even if the rheostat
or dimmer channel is used solely for 0% to 100% switch.
• The installation has to be approved by an expert before the device is taken into service.
7. Operation
Refer to the illustrations on page 2 of this manual.

Control Panel Navigation

• Access the control panel functions using the four panel buttons located directly underneath the LCD
display.
button
<MENU>
<DOWN>
<UP>
<ENTER>
• The control panel LCD display shows the menu items you select from the menu map. When a menu
function is selected, the display will show immediately the first available option for the selected
menu function. To select a menu item, press <ENTER>.
• Use the <UP> and <DOWN> buttons to navigate the menu map and menu options. Press
<ENTER> to access the menu function currently displayed or to enable a menu option. To return to
the previous option or menu without changing the value, press the <MENU> button.
Menu Functions
menu sub-menu
p1
p2
p3
p--
p4
p5
p6
3-ch d001-d512
7-ch d001-d512
c1
c2
c3
c-- c4
c5
c6
c7
s-- 5001-5100
r---
u-- g---
b---
10.01.2011
VDPLP64SL
used to access the menu or to return to a previous menu option
scrolls through the menu options in descending order
scrolls through the menu options in ascending order
used to select and store the current menu or option within the menu
function
7-colour switching
7-colour fading
7-colour switching
7-colour fading
7-colour sound control
3-colour sound control
-
-
red
green
blue
cyan
magenta
yellow
white
5050
default range
red
green
blue
function
description
select between 2 switching and 2 fading built-in
select between 2 sound-active programs
use sound sensitivity adjustment knob [5]
select 3-channel DMX mode (RGB)
select 7-channel DMX mode (RGB, macros, run
speed, strobe, automatic/sound, dimmer)
select between 7 static colours
speed range for 2 switching and 2 fading built-in
combine red, green and blue to create your own
custom colour
5
programs
programs
000~100
©Velleman nv