English
‧ Read and observe all the important notices on the appliance and
its cord.
‧ If an extension cord is necessary, a cord with a proper rating
should be used. A cord rated for less amperes or watts than the
appliance rating may overheat. Care should be taken to arrange
the cord so that it will not be tripped over or pulled.
‧ This appliance has a polarized plug (one blade is wider than the
other). As a safety feature, this plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet, reverse the plug.
If still does not fit, contact a qualified electrician. Never use with an
extension cord unless plug can be fully inserted. Do not attempt to
defeat this feature.
‧ Check that the voltage shown on the label of the unit corresponds
to the voltage of the mains supply.
‧ Disconnect all electrical appliances from the mains before placing
hands in the water.
‧ The line cord of this unit cannot be replaced or repaired. Should
the line cord become damaged the appliance must be discarded.
KEEP THESE INSTRUCTIONS
FOR FUTURE REFERENCE.
3. Safety instructions
Risks for persons and property can arise from this appliance if the appliance is im-
properly used or not used as intended or if the safety instructions are not heeded.
For your safety
‧ This appliance can be used by children from
the age of 8 and by persons with reduced
physical, sensory or mental capabilities or
lack of experience and/or knowledge if they
are supervised and have been instructed
in the safe use of the appliance and have
understood the resulting dangers. Children
must not play with the appliance. Cleaning
and user maintenance must not be carried
out by children unless they are supervised.
‧ Before use, carry out a visual inspection to
ensure that the appliance, especially the
mains cable and plug, are undamaged. Make
sure that the glass body of the heating rod is
not broken or cracked.
‧ Before commissioning, the appliance must
be immersed to the MIN. WATER LEVEL
marking underneath the water, and no less.
The appliance must never be operated out
of water.
‧ After disconnection from the mains, the appli-
ance must be left in the water for 30 minutes
in order to cool down.
10