EHEIM thermocontrol e 25 Manual De Instrucciones página 11

English
‧ A hot appliance must never be placed on
heat-sensitive surfaces!
‧ Repairs must only be carried out by an
EHEIM service centre.
‧ The mains cable of this appliance cannot be
replaced. If the cable is damaged, the appli-
ance must be scrapped.
‧ Only carry out the work described in these
instructions.
‧ Only use original spare parts and accessories
for the appliance.
‧ We recommend protecting all electrical
aquarium appliances via a residual current
protective device with a rated residual current
of 30 mA maximum.
‧ If they are not being used, always disconnect
all devices in the aquarium from the power
supply before you install/remove any parts
and before all cleaning and maintenance
work.
‧ Protect the mains socket and
mains plug against moisture
and wetness. A drip loop
must be formed with the
mains cable.
This prevents any water running along the
cable to the mains socket, which would result
in a short-circuit.
‧ The electrical data of the appliance must
match the data of the power mains. This data
is found on the type plate, the packaging and
in these instructions.
‧
‧ Danger of burning! The appliance is very hot
during and directly after operation. Never
touch hot parts or the heating zone
4. Commissioning
Installing the heater (⌦A)
1. Remove the transportation protection
2. Connect the suction device
3. Connect the suction device mount to the heater (not in the area
4. Attach the appliance below water level on the inside of your
of the heating zone
aquarium (⌦C). Take the minimum water level and maximum
immersion depth into account.
to the suction device mount
b
and the control light
d
11
!
d
.
e
).
c
.
a