Sealing The Film - Bifinett KH 1605 Instrucciones De Uso

Slide the cutter
q
way to the other side.
Note:
The film will only be cut when you slide the cutter
q from left to right!

Sealing the film

Attention:
For sealing use only films made of PE-HD (Polyethy-
lene of high density). Otherwise, the sealing seam
will not be tight and the appliance could be damaged.
You can recognise films of this type by the inscription
"PE-HD" on the packaging.
Attention:
Do not heat the supplied film, for example in a water-
bath or similar. It is construed for temperatures of
a maximum of 60°C.
Press simultaneously on the two unlocking
devices left and right
a
appliance cover
u
Lay the end of the film tube to be sealed over
the sealing wire
t
Place the selector switch
"Seal".
Then close the appliance cover
the film tube does not slip off of the sealing
wire t .
Press down the appliance cover
sides until it audibly clicks in at left and right.
over the film and all the
and open up the
i
.
.
into the position
h
. Ensure that
u
on the outer
u
Press and hold the broad button
hands until the control lamp
Hold the button pressed down until the control
lamp goes out.
Note:
To achieve the best results, press the button
down continuously, applying an even pressure
and using both hands.
Warning:
If the control lamp
y
of 10 seconds, the appliance is defective! Immediately
remove the plug from the wall socket. Do not attempt to
repair the appliance yourself. In this case, contact
Customer Services.
Re-open the appliance cover
above, and remove the film. This is now sealed
at one end to a bag. This bag can now be filled
and the other end sealed by the same proce-
dure.
Warning:
Fill the bags in such a way that, under no circum-
stances, food remnants or fluids can run out of the
bag when sealing it and permeate into the appliance.
- 20 -
with both
o
lights up.
y
does not go out after a maximum
, as described
u
o