Operating Procedures - Hitachi Koki TCH 22EPAP Instrucciones De Seguridad Y Manual De Instrucciones

English

OPERATING PROCEDURES

Fuel (Fig. 7)
WARNING
○ Do not use fuel with more than 10%
ethanol in this unit.
Use of fuel, such as E15 (15%
ethanol), E20 (20% ethanol), E85
(85% ethanol), may cause problems
including overheating, premature
deterioration of fuel lines and carburetors.
Use of fuel with more than 10% ethanol may
result in personal injury or property damage.
Use of fuel with more than 10% ethanol will void
the product warranty.
Check the ethanol level before purchasing fuel
for this unit.
○ This unit is equipped with a two-stroke engine.
Always run the engine on fuel, which is mixed
with oil.
Provide good ventilation, when fueling or
handling fuel.
○ Fuel contains highly fl ammable and it is possible
to get the serious personal injury when inhaling
or spilling on your body. Always pay attention
when handling fuel. Always have good ventilation
when handling fuel inside building.
Fuel
○ Always use branded 89 octane unleaded
gasoline.
○ Use genuine two-cycle oil or use a mix between
25:1 to 50:1, please consult the oil bottle for the
ratio or Tanaka dealer.
○ Only for the state of California at 50:1.
○ If genuine oil is not available, use an anti-oxidant
added quality oil expressly labeled for air-cooled
2-cycle engine use (JASO FC GRADE OIL
or ISO EGC GRADE). Do not use BIA or TCW
(2-stroke water-cooling type) mixed oil.
○ Never use multi-grade oil (10 W/30) or waste oil.
○ Always mix fuel and oil in a separate clean
container.
8
Fig. 7
Always start by fi ling half the amount of fuel, which
is to be used. Then add the whole amount of oil. Mix
(shake) the fuel mixture. Add the remaining amount
of fuel.
Mix (shake) the fuel-mix thoroughly before fi lling the
fuel tank.
Fueling
WARNING
○ Always shut off the engine before refueling.
○ Slowly open the fuel tank, when fi lling up with
fuel, so that possible over-pressure disappears.
○ Tighten the fuel cap carefully, after fueling.
○ Always move the trimmer at least 10 ft (3 m) from
the fueling area before starting.
○ Always wash any spilled fuel from clothing
immediately with soap.
○ Be sure to check for any fuel leakage after
refueling.
Before fueling, clean the tank cap area carefully,
to ensure that no dirt falls into the tank. Make sure
that the fuel is well mixed by shaking the container,
before fueling.
Starting
CAUTION
Before starting, make sure the cutting attachment
does not touch anything.
1. Set ignition switch (13) to ON position. (Fig. 8)
14
* Push priming bulb (15) several times so that
fuel fl ows through return pipe. (Fig. 9)
13
Fig. 8
15
Fig. 9