Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SLEEP FUNCTION (by remote control)
1. If you want to fall asleep to music, press the SLEEP button .
2. You may select the TUNER, iPod orAUX mode in sleep function to play from 90, 80, 70 up
to 10 minutes of music before shutting itself off automatically.
FUNCTION SELECT
1. Press repeatedly the FUNCTION button (12) on the unit or on the remote control (9) to
select the desired. Display changes as: iPod - TUNER - AUX-IN.
FM RADIO OPERATION
Operation
•
Press the STANDBY Button on the unit (23) or the remote control (1) to turn the unit on.
•
Select the TUNER function with the Function Button on the unit (4) or on the remote control (9).
•
There are a number of ways that you can tune to radio stations. Follow the instructions
in the sections below.
•
Adjust the VOLUME to the desired level using the VOLUME -/+ Knob (15) or the VOLUME
-/+ Buttons (8,21) on the remote control .
•
To turn off the radio, press the STANDBY Button again.
Manual Tuning
Manual tuning is useful when you already know the frequency of the desired transmitter.
•
To change the frequency, repeatedly press the TUNE/CLK+ or TUNE/CLK- from Remote
Control until the precise frequency is reached.
•
From the main unit press the Jog Mode button (19) and rotate the Volume/Tune knob until
the precise frequency is reached.
Automatic Tuning
•
Press and hold the TUNE/CLK+ or TUNE/CLK- Buttons for about a second. The radio
will start automatically scanning for strong radio signals. The TUNER Display shows the
frequency in MHz for Fm.
English
7
8
English
•
The tuner will stop scanning when it finds a strong signal.
•
Repeat this process until the desired station is found.
Notes: As automatic tuning depends on the signal strength of the transmitters, weak
transmitters are sometimes skipped. In such a case, tune manually to find the
weaker transmitters.
On the other hand, with a very strong signal, the tuner may stop before it reaches
the optimum setting. Tune manually for the best reception.
Storing Stations (from Remote Control only)
This unit allows you to store the frequencies of up to 20 radio stations in the memory;
•
First tune into the station you want to store using one of the methods above.
•
Then press the Preset Menu button (11) on the remote control (17).
•
Press PRESET-UP or PRESET-DN Buttons the remote control (3,4) to select the desired
channel memory and press the Preset Menu button (11) within 5 seconds to store it.
To reprogram a preset station repeat the procedure above.
Selecting a preset station
To select a preset station, press the Jog/Mode button and turn the Volume/Tune knob on main
unit or press the PRESET-UP or PRESET-DN Buttons on the remote control (3,4) until the
desired preset program is displayed.
FM Stereo Reception
When an FM signal is tuned in, the ((( ST. ))) indicator will appear in the display.
In case of noisy reception, if you push the PLAY/PAUSE MONO-STEREO button (9) to FM
MONO position, the FM STEREO indicator will turn off & switch to MONO FM status.
Antenna
For FM reception there is a wire antenna (17) at the rear of the unit. Extend it for best reception.
Publicidad
Tabla de contenido
