Commissioning - Gloria Hobby 1200 Instrucciones De Uso

RZ_KRSG_EN.qxp_Text_EN 01.10.18 15:53 Seite 24
Type Hobby 1200/1800: Padded shoulder strap
Pass upper loop through the middle slot. Insert the mounting element into the loop. Pull the
2
strap back until it is caught in place.
Pass the two lower strap ends as shown through the metal strap buckles.
3
Type Hobby 1800: Additional lap belt
Mount the lower holding points as shown for the lap belt.
4
Pass the upper straps through the left and right slots and then pull through the strap buckles
5
as shown.
Type Pro 1300/1800: Carrier system with chest strap (model Pro 1800 includes a lap belt)
Pass the upper middle strap through the middle slot and pull through the strap buckle as
6
shown.
Then mount the lower 4 holding points (2 outside / 2 inside) for the carrier system as shown.
7
Pass the upper outer straps respectively through the left and right slots and then pull through
8
the strap buckles as shown.
5.2 Pump grip >>
The device types Pro 1300/1800 are equipped with an ergonomic handle which must be moun-
ted appropriately for left or right-hand use.
Mount the handle facing the left or right-hand side on the pump lever. Insert the handle
9
sections on the pump lever as shown.

NOTE
lever arm of the pump lever according to the mounted handle position.

Insert the holding clip for the spraying lance as shown. Then attach the second handle section
and screw both handle sections to the pump lever as shown
5.3 Quick closure valve/hose/spraying lance >>
Insert the seal into the connecting nozzle and then screw this on to the screw threaded
10
coupling on the pump housing.
Push the hose up to the stop on the connection sleeve of the pump housing and screw
11
down tight with the coupling nut.
12
Screw the pressure control valve onto the quick closure valve.
Push the hose up to the stop on the connection sleeve of the quick closure valve and
13
screw down with the coupling nut. Screw the spraying lance onto the quick closure valve.
Mount an extension if required (except type Hobby 1200).
6

Commissioning

DANGER
WARNING
leaking components may result in draining or spouting of spraying pesticides. You should
therefore observe the following safety instructions:
 Prior to each use, check the device to ensure fault-free condition and leak-tightness.
To perform the leak test, fill the container with water!
 Inspect all screw joints for tight fitting.
Figure 9
You can choose between 2 insert positions which will shorten or extend the
Before putting into operation, observe Chapter 2 "For your safety".
Danger to health due to escaping spraying pesticides! A leaking device or
.
Figures 10 - 13
24