babymoov A014403 Manual De Instrucciones página 10

B / Receiver
1. Operation from battery pack
The Li polymer battery pack is already installed in
the unit.
2. Recharging and operation on the base
When the LED (4) positioned under the control panel
of the monitor turns orange or red, it indicates that
the Li-battery is flat.
Connect the output plug of C 6V adapter to DC jack
(11) of the base. Connect the adapter to the mains.
Place the receiver on its base.
The charge indicator (10) on the base turns green
indicating that the charge is running.
- If the monitor is turned Off, the light (4) is initially
red and turns green when the battery is fully
charged.
- If the monitor is turned On, the light (4) is initially
orange and turns green when the battery is fully
charged.
3. Operation on mains
You can directly use the receiver on mains by
connecting the C adapter to the DC Jack (7) of the
receiver.
The baby and parent unit are already paired when you use them for the first time. You can use them
immediately without carrying out this step. This babyphone can be operated with up to 4 cameras. To connect
extra cameras, please follow the instructions below:
1. Press the + button on the receiver's display brightness control (2), while making sure the On/Off button
(6) is switched to On. The screen then displays the message "Pair ID for Cam1... ".
2. Using a pointed object, press the connection button located in the small hole (19) on the base of the camera.
The camera's indicator light (12) starts to flash.
3. The connection is made and the screen displays the message "Pair ID for Cam 1...Cam 1 OK!".
4. Repeat steps 2 and 3 for any other cameras that you wish to connect.
5. Switch the device off and then on again in order to return to normal operating mode.
Receiver
1. Volume control (+/-)
2. Screen brightness control (+/-)
3. LCD screen
4. Battery level indicator
5. Speaker
6. Power and screen On/Off switch
7. DC Jack
8. Camera selection button (preset to 1)
9. Reset button
Charger
10. Charging indicator
11. DC Jack
10
P IRING
CONTROLS L YOUT
B BY MONITOR VISIO C RE • Instruction Manual
Transmitter
12. Microphone
13. Power indicator
14. Camera lens
15. Nightvision LED's
16. Rainbow nightlight
17. DC Jack
18. Vox/On/Off and Nightlight switch
19. Power In/Off switch
20. VOX/On camera switch
21. Reset button / camera connection button