Skil HD529501 Manual Del Propietário página 19

Metal Drilling
For maximum performance, use high-speed steel bits for metal or steel drilling.
When drilling metals, use light oil on the drill bit to keep it from overheating. The oil will
•
prolong the life of the bit and increase the drilling action.
Begin drilling at a very low speed to prevent the bit from slipping off the starting point.
•
Maintain a speed and a pressure that allow cutting without overheating the bit. Applying too
•
much pressure will:
Overheat the drill.
–
Wear the bearings.
–
Bend or burn bits.
–
Produce off-center or irregularly shaped holes.
–
Masonry Drilling
For maximum performance, use carbide-tipped masonry bits when drilling holes in brick, tile,
concrete, etc.
Maintain a speed and a pressure that allow cutting without overheating the bit or Drill.
•
Applying too much pressure will:
Overheat the Drill.
–
Wear the bearings.
–
Bend or burn bits.
–
Produce off-center or irregular-shaped holes.
–
Apply light pressure and medium speed for best results in brick.
•
Apply additional pressure for hard materials such as concrete.
•
When drilling holes in tile, practice on a scrap piece to determine the best speed and
•
pressure.
Begin drilling at a very low speed to prevent the bit from slipping off the starting point.
•
NOTICE: Fig.13 shows some tips for different drilling operations.
Fig. 13
Dust-free drilling in walls
Dust-free drilling in ceilings
Drilling in tiles without
skidding
19