Controls And Their Functions - Yamaha NS-SW500 Manual De Instrucciones

2
Front
panel
3
4 5
7 8
!
#
Rear panel

CONTROLS AND THEIR FUNCTIONS

1 Indicator
1
Green: The subwoofer is turned on.
Red: The Automatic power-switching function
has activated, and the subwoofer is in
standby mode.
Off: The subwoofer is turned off.
Top panel
2 Port
Outputs super-bass sound.
3 OUTPUT (TO SPEAKERS) terminals ( page 3)
Can be used for connecting to the main speakers.
Signals from the INPUT1 terminals are sent to these
terminals.
4 INPUT2 (NORMAL) terminals ( page 3)
Used to input line level signals from the amplifier.
5 INPUT3 (LFE) terminals ( page 3)
The HIGH CUT control ! has no effect on the signals
6
input to these terminals.
6 SYSTEM CONNECTOR jack ( page 5)
Connect the supplied system control cable here. If you
use the system control cable to connect a subwoofer to
a Yamaha component (that features a system connector
jack), turning on or off the power to the connected
9
)
component automatically turns the subwoofer on or off.
7 INPUT1 (FROM AMPLIFIER) terminals ( page 4)
Used to connect the subwoofer with the speaker
terminals of the amplifier.
8 AUTO STANDBY (HIGH/LOW/OFF) switch
( page 5)
This switch is originally set to the OFF position. By
@
setting this switch to the HIGH or LOW position, the
subwoofer's automatic power-switching function
operates. If you do not need this function, leave this
switch in the OFF position.
Note
$
Be sure to set the POWER switch to OFF before you set
the AUTO STANDBY switch.
9 PHASE switch ( page 6)
This switch is to be set to the REV (reverse) position.
However, depending on your speaker system or listening
conditions, there may be a case when better sound quality
is obtained by setting this switch to the NORM (normal)
position. Select the best position by ear.
) B.A.S.S. (Bass Action Selector System) switch
( page 6)
When this switch is set to
MUSIC, the bass sound in
audio software is well
reproduced. When the switch is set to MOVIE, the bass
sound in video software is well reproduced.
! HIGH CUT control ( page 6)
Adjusts the high
frequency cut off point.
* One graduation
of this control
Frequencies higher than
represents 10 Hz.
the frequency selected by
this control are all cut off (and not output).
@ VOLUME control
Adjusts the volume level. Turn the control clockwise to
increase the volume, and counterclockwise to decrease
the volume.
# POWER switch
During normal usage, set this switch to ON. If you plan
not to use the subwoofer for a long period of time, set
the switch to OFF.
$ VOLTAGE SELECTOR switch
(Asia and General models only)
If the preset setting of the switch is incorrect, set the
switch to the proper voltage (110-120 V/220-240 V) of
your area.
Consult your dealer if you are unsure of the correct
setting.
WARNING
Be sure to unplug the subwoofer before setting the
VOLTAGE SELECTOR switch correctly.
2
En