Connecting To Speaker Output Terminals Of The Amplifier; Connecting To The Input1/Output Terminals Of The Subwoofer - Yamaha NS-SW500 Manual De Instrucciones

Connecting to speaker output terminals of the amplifier

2
■
Example: Connecting the subwoofer to an amplifier that
features one set of speaker output terminals
Use speaker cables to connect the speaker output terminals of the amplifier to the
subwoofer's INPUT 1 (FROM AMPLIFIER) terminals. Connect the front speakers to the
subwoofer's OUTPUT (TO SPEAKERS) terminals. Although the subwoofer is connected
between the front speakers and the amplifier, the sound volume or quality will not be
affected.
Connecting one subwoofer
Subwoofer
Right front
speaker
To AC outlet
Amplifier or
receiver
Connecting two subwoofers
Right front
speaker
Subwoofer
Speaker output
Amplifier or
receiver
To AC outlet
Left front
speaker
Speaker output
terminals
terminals
To AC outlet
■
Example: Connecting the subwoofer to an amplifier featuring two
sets of speaker output terminals (A and B) that can output sound
signals simultaneously
Set the amplifier so that both sets of speaker output terminals (A and B) will output
sound signals simultaneously. Then, connect the front speakers to terminals A, and
connect the subwoofer to terminals B.
Note
If your amplifier features two sets of speaker output terminals that do NOT output sound
signals simultaneously, please refer to the example for connecting an amplifier that has
only one set of speaker output terminals (see the figure on the left).

Connecting to the INPUT1/OUTPUT terminals of the subwoofer

■
Before connecting
Remove 10 mm (3/8") of insulation from the ends of the
speaker cables.
■
How to connect
1.
Loosen the terminal's knob, as shown in the figure.
2.
Insert the bare wire.
3.
Tighten the knob.
4.
Test the firmness of the connection by pulling lightly
on the cable at the terminal.
■
Connecting the banana plug
1.
Tighten the terminal knob.
2.
Simply insert the banana plug into the terminal.
Left front
Notes
speaker
• Make sure that the "+" and "–" polarity markings of the speaker cables are observed and set
correctly. If these cables are reversed, the sound will be unnatural and lack bass.
Subwoofer
• Do not let the bare speaker wires touch each other, because this could damage the subwoofer
or the amplifier.
• If the connections are faulty, no sound will be heard from the subwoofer or the speakers. Do
not insert the insulation into the hole. Sound may not be produced.
• To avoid accidents resulting from tripping over loose speaker cables, fix them to the floor.
10 mm
(3/8")
Good No Good
2
1
Red:
positive (+)
3
Black:
–
negative ( )
1
2
4
En