Main Features - Velleman CS300 Manual Del Usuario

Ocultar thumbs Ver también para CS300:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for buying a Velleman product! With your CS300 metal detector, you can search for coins, relics, jewellery,
gold and silver just about everywhere.
Please read the manual thoroughly before bringing this device into service. If the device was damaged in transit, don't
install or use it and contact your dealer. Damage caused by disregard of certain guidelines in this manual is not
covered by the warranty and the dealer will not accept responsibility for any ensuing defects or problems.

2. Main Features

Non-Motion Detection Mode: Only in ALL-METAL mode. In this setting, the metal detector will sound only when the
target is located under the search coil – you will not need to sweep the detector.
Motion Detection Mode: Can be used in ALL-METAL, DISCRIMINATION, NOTCH and AUTO NOTCH modes. A
target cannot be detected unless you sweep the search coil.
3. Description
a. The Metal Detector (fig. 1)
1. search coil
2. knob
3. locking nut
4. cable
5. armrest
6. nut
7. stem
b. The Control Panel (fig. 2)
1. target indicator
2. LCD
3. GND BAL or ground balance
4. SURF ELIM or surface elimination – can be used in DISCRIMINATION, NOTCH and
AUTO NOTCH modes. Used to eliminate metallic particles in the surface.
5. GND TRAC or Ground Trac
Permits the unit to maintain optimum ground balance at all times.
6. VOL or volume
7. MODE or mode selector
8. ADJ or adjustment button for sensitivity and discrimination range
9. ENT or enter – confirming or rejecting the target in NOTCH mode
10. POWER
CS300
CS300 – METAL DETECTOR WITH LCD
– can be used in ALL-METAL mode.
®
6
7
3
1
2
3
4
5
7
8
9
10
1
2
3
4
5
6
VELLEMAN

Publicidad

Tabla de contenido
loading

Tabla de contenido