To Apply And Release The Parking Brake, M125-85Fh; Maintenance Schedule; To Apply And Release The Parking Brake, M125-85F; Maintenance - McCulloch M125-85F Manual De Usuario

3. Pull the throttle control rearward to decrease the
engine speed.
a) For M125-85F, put the gearshift lever in the
neutral position (N).
N
4. Turn the ignition key to the STOP position.
5. When the product stops, apply the parking brake.
To apply and release the parking
brake, M125-85FH
1. Move the parking brake lever fully forward.
2. Move the parking brake lever to the left to keep it in
the forward position.
3. To release the parking brake, move the parking
brake lever to the right and rearward.
Introduction
WARNING: Before you do any maintenance
work you must read and understand the
safety chapter.

Maintenance schedule

* = General maintenance done by the operator. The
instructions are not given in this operator's manual.

Maintenance

Make sure that nuts and screws are tightened
Make sure that there are no fuel or oil leaks
To clean the product on page 17
Clean as given in
16
To apply and release the parking
brake, M125-85F
1. Press the parking brake pedal down (A).
2. Press and hold the lock button (B).
3. Keep the button pressed and release the parking
brake pedal.
4. To release the parking brake, press the parking
brake pedal again.
To get a good result
• Do not cut a wet lawn. Wet grass can give a bad
result.
• Start with a high cutting height and decrease it
gradually.
• Cut with blades that rotate at high speed (highest
permitted engine speed, see
26 ). Move the product forward at low speed. If the
grass is not too high and thick, you can get a good
result also at a higher speed.
• To get the best result, cut the grass frequently and
use the mulch function.
Maintenance
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Let an approved service agent do the
maintenance.
Note: If more than one time interval is identified in the
table, the shortest time interval is for the first
maintenance only.
Daily maintenance
before operation
B
A
Technical data on page
Maintenance interval
in hours
25
*
*
X
623 - 001 - 06.03.2018
50 100 200