Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Second step:
Connect the control boxes one to each other, to the terminals A and B, keeping the letter order (See figure below -
connect terminal A from the control box 1 to the terminal A of the control box 2, etc...).
This cable must be a two wire shielded twisted pair cable, with a minimum section of
AWG24 and a maximum length of 1000m.
SETTING OF FIRST LEVEL:
To modify the setup airflow press the key
SETUP AIRFLOW
< xxxm3/h
To change the value press the key
To confirm press the key
TEMP. ARRET
< xxºC
To change the value press the key
To confirm press the key
For the last fan of the fan network, place the switch SW1 located on the PCB of control
box, on position "ON".
For all the other fans this switch must be on position "OFF"
OK
or
.
OK
or
.
.
3 seconds:
.
Publicidad
Tabla de contenido
