Tips About Indicator Panel - Sharp AY-XPC7JHR Manual De Instrucciones

When using your air-condi-
tioner with multi-system
With a multi system air conditioner, mul-
tiple indoor units can be connected to
one outdoor unit. When the setting mode
differs among indoor unit(s), the indoor
unit(s) operated later may not work.
• When the indoor unit(s) is/are operating in
HEAT mode, the remaining unit(s) can not
operate in COOL or DRY mode.
• When the indoor unit(s) is/are operating in
COOL or DRY mode, the remaining unit(s)
can not operate in HEAT mode.
When the mode of the indoor unit(s) later op-
erated is/are different from those which is/are
in operation, after a few seconds, a long BEEP
will be emitted and the temperature indicator
on the indicator panel will indicate"
the OPERATION lamp and TIMER lamp will
blink alternately. This shows that the later op-
erated unit(s) is/are not working. In such case,
change the mode to the same mode which the
other indoor unit(s) is/are operating in.
TIPS ABOUT AUTO MODE
In the AUTO mode, the temperature setting
and mode are automatically selected accord-
ing to the room temperature and outdoor
temperature when the unit is turned on.
• During operation, if the outdoor tempera-
ture changes, the temperature settings will
automatically slide as shown in the chart.
Modes and Temperature Settings
The fi gures in ( ) are temperature settings
• When using your air-conditioner with multi-
system, mode of the unit operated first
will have priority over other unit(s) without
reference to the above chart.
TIPS ABOUT INDICATOR
PANEL
The indicator panel will change each time
you press the DISPLAY button in the fol-
lowing manner.
Display button
" and
Outdoor Temp.Lamp light up
NOTES:
• The displayed temperatures are rough estimates
and may vary from the actual temperatures.
• Temperature display ranges
Room temperature: 0°C ~ 40°C (
when less than 0°C and
C)
Outdoor temperature: –9°C ~ 45°C (
displayed when less than –9°C and
higher than 45°C)
• is displayed during the first about 0~120
seconds of operation while the temperatures are
being detected.
• During SELF CLEAN operation, the indicator
panel will display remaining time of the operation.
Room and outdoor temperature will not be
displayed even if you press the DISPLAY button.
Single use
• Only the room temperature can be displayed for 5
seconds when the unit is not in operation.
Multi use
• is displayed for 5 seconds when the unit is not
in operation.
GB-7
The room
temperature is
displayed .
temperature Indiactor
The outdoor
temperature is
displayed.
temperature Indiactor
No display.
is displayed
when higher than 40°
is
when