Operation - Rigid AC9945 Manual Del Operador

OPERATION

WARNING:
Do not allow familiarity with this product to make
you careless. Remember that a careless fraction of
a second is sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1. Failure to do
so could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal
injury.
APPLICATIONS
You may use this product for the purpose listed below:
 To provide a stable, secure work surface for a miter
saw.
USING THE SUPPORT ARMS
See Figures 18, page 17.
Use the support arms when working with longer workpieces.
Both support arms may be adjusted to provide maximum
workpiece support.
To extend the support arms:
 Lift the support arm locking lever to the open position.
 Extend the support arm to the desired position.
 Push the locking lever down to the lock position.
To retract support arm:
 Lift the support arm locking lever to the open position.
 Push support arm fully into MSUV.
 Push the support arm locking lever down to the lock
position.
USING THE WORK SUPPORT
See Figure 19, page 18.
Rest the workpiece on top of the work support to support
the workpiece during cutting operations.
Place the workpiece against the work stop whenever you
need to make repetitive cuts of the same size.
To adjust the work support:
 Loosen the height adjustment knob.
 Adjust the work support to the desired position.
 Tighten the height adjustment knob.
To adjust work stop:
 Loosen the work stop adjustment knob.
 Raise or lower the work stop to the desired position.
 Tighten the work stop adjustment knob.
TRANSPORTING THE MSUV
 Retract the support arms and place the unit in the vertical
closed position.
 Stand at the wheel side of the MSUV and grasp the
handles.
 Tilt the MSUV toward you until it balances on the wheels,
then roll the MSUV to the desired location.
STORING THE MSUV
 The MSUV should be stored on a stable flat surface in
the vertical or horizontal closed position.
CAUTION:
If the utility vehicle will not remain upright, store in
the horizontal closed position. Failure to do so may
result in MSUV falling, resulting in injury or damage
to stand and/or saw.
9 – English